![]() ![]() I would be willing to trade but not willing to give them away. Most of the models can be seen in my buggy build thread in my signature. ![]() I also modeled the Ecotec, sky bell housing, AX-15, D300, NP231, D60, D44 unit bearings, Seats etc. Then I basically model every part I buy before installing from coolers to carbs starter, alternators, fuel cells, etc most are just close but good enough for envelope drawings. Some I just guess all together, from pictures. I did this for willwood brakes, CNC cutting brakes, atlas, ORI struts, flat pieces I just scan in and put under my sketch plane. I use a lot of their 2D drawings place them under the sketch scale, then trace. When it comes to off road racing seats, it really doesnt get better than the Baja XP, seriously though, it doesnt Years of research and design have gone. It would be nice if manufactures would upload envelopes of there models. ![]() I tried searching where I could buy models to speed things up with no luck just sites like this one with nothing on them I've downloaded a few off there to see what I get I couldn't open most of them up. Click to expand.Yes, but I would be willing to pay for accurate models. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |